SmartThings Support

Fibaro Flood Sensor

The Fibaro Flood Sensor is a Z-Wave moisture sensor that can be used with SmartThings to monitor for leaks and changes in interior temperatures. Paired with the SmartThings Hub and mobile app, the Fibaro Flood Sensor can be used to send push notifications to your phone when water is detected or the temperature swings too hot or cold.

It's perfect for under your sink, by your clothes washer, or in your basement.

 

To connect the Fibaro Flood Sensor with the SmartThings Hub

In the SmartThings mobile app:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. While the Hub searches, pull the battery tab from the Fibaro Flood Sensor
    • If the battery tab has already been removed, twist open the cover on the sensor and quickly press the lever on the sensor's circuit board 3 times. Twist the cover back in place immediately after pressing the lever. Allow the app up to 2 minutes to discover the device
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm

 

To reset the Fibaro Flood Sensor

If the Fibaro Flood Sensor was not discovered, you may need to reset, or “exclude,” the device before it can successfully connect with the SmartThings Hub. To do this in the SmartThings mobile app:

  1. Tap the menu (Android) / More (iOS)
  2. Tap the Hub
  3. Tap Z-Wave Utilities
  4. Tap General Device Exclusion
  5. When prompted, twist open the cover on the sensor and quickly press the lever on the sensor's circuit board 3 times

After the app indicates that the device was successfully removed from SmartThings, follow the first set of instructions above to connect the Fibaro Flood Sensor.

 

To remove the Fibaro Flood Sensor from SmartThings

If the Fibaro Flood Sensor is connected but not operating as normal, you may need to remove the device and reconnect it with the SmartThings Hub.

To remove the device via the SmartThings app:

  1. Tap My Home
  2. Tap Things
  3. Select the device
  4. Tap the gear icon 
  5. Tap Remove
  6. Confirm removal
  7. When prompted, perform the exclusion procedure to remove the device from the mobile app and from the SmartThings Hub

 

Note: Follow these steps to configure your Fibaro Flood Sensor if its data isn’t displaying correctly in the app.

 

Technical Details

  • Dimensions: 1.4" x 3.7" x 3.8"
  • Overall Weight: 3.2 ounces
  • Model Number: FGFS-101

 

Get In Touch

Reach us by phone
1-800 SAMSUNG
1-800-726-7864
9 am to 6 pm Pacific Time, Monday through Saturday
Reach us on live chat
9 am to 5 pm Pacific Time, Monday through Saturday
Powered by Zendesk