SmartThings Support

Samsung SmartThings Moisture Sensor

By placing the Samsung SmartThings Moisture Sensor/Water Leak Sensor in an area of your home that is prone to water damage (such as in a basement, near a water heater, under an old pipe, or in a bathroom), you can receive an immediate alert on your smartphone at the first sign of a leak. You can also use this wireless ZigBee sensor to trigger lights or sirens to turn on and alert you when water is detected.

 

How to connect the Samsung SmartThings Moisture Sensor/Water Leak Sensor to the SmartThings Hub

Follow the instructions below or consult the Moisture Sensor/Water Leak Sensor’s Quick-Start Guide at the bottom of this article.

In the SmartThings mobile app:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. While the Hub searches, move the Moisture Sensor/Water Leak Sensor within 15 feet of the Hub and pull the REMOVE TO PAIR tab on the sensor
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm

 

Watch this video demonstration to see how to connect the SmartThings Moisture Sensor/Water Leak Sensor:

 

How to reset the Samsung SmartThings Moisture Sensor/Water Leak Sensor

If the Samsung SmartThings Moisture Sensor/Water Leak Sensor didn't connect to the Hub when you removed the pull-tab, reset and connect the device manually.

First:

  1. Remove the cover of the Moisture Sensor/Water Leak Sensor
  2. Remove the CR2 battery by pulling the ribbon

Next, put the Hub in join mode:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…

Last, while the Hub searches:

  1. Move the Moisture Sensor/Water Leak Sensor within 15 feet of Hub
  2. Hold down the Connect button on the Moisture Sensor/Water Leak Sensor while reinserting the battery
  3. Release the button when the LED is lit
  4. The LED will blink blue while attempting to connect
  5. Once the app shows a device has been found, put the cover back on the Moisture Sensor/Water Leak Sensor
  6. Follow the configuration steps above

 

Watch this video demonstration to see how to reset the SmartThings Moisture Sensor/Water Leak Sensor:

 

How to remove the Samsung SmartThings Moisture Sensor/Water Leak Sensor from SmartThings

If the Moisture Sensor/Water Leak Sensor is not performing as expected, you may need to reset the device and/or remove and reconnect the device with the SmartThings Hub.

To remove the device via the SmartThings app:

  1. Tap My Home
  2. Tap Things
  3. Select the Moisture Sensor/Water Leak Sensor
  4. Tap the gear icon
  5. Tap Remove
  6. Confirm removal (this cannot be undone)

 

Technical Details

  • Dimensions: 2.34 x 1.49 x 0.85 inches, 59.4 x 37.8 x 21.6 mm
  • Weight: 0.088 lb, 1.4 oz
  • Operating Temperature: 32 to 104°F, 0 to 40°C (indoor use only)
  • Power Source: CR2 battery (included)
  • Communication Protocol: ZigBee
  • Warranty: Find warranty information here
  • Range: 50-100 feet (depending on your home's construction)

 

Attachments

File Size
QSG_WaterLeak_US_Mobil_0.0.pdf 400 KB

Get In Touch