SmartThings Support

How to connect Intermatic devices

With Intermatic Z-Wave devices and SmartThings, you can turn ordinary outlets or lamps into smart devices. This provides both control from your phone and the ability to automate when your lights turn on or off based on events like motion, time of day, sunrise or sunset, etc. These devices also work as repeaters for other Z-Wave devices on your network.

Note: Intermatic devices are not officially supported Works with SmartThings devices. You can connect them to your SmartThings Classic setup, but performance may vary and we will not be able to provide support or assistance.


This article will tell you how to connect the following Intermatic devices with SmartThings:

  1. Intermatic HA03C Indoor Lamp Module (pictured above)
  2. Intermatic HA02C Heavy-Duty Appliance Module
  3. Intermatic HA05C Screw-In Module
  4. Intermatic HA01C Wall Receptacle
  5. Intermatic HA04C Home Settings Wireless Heavy­-Duty Outdoor Lighting Module


To connect the Intermatic device with the SmartThings Hub

From the SmartThings Classic app:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. While the Hub searches, press and release the programming button
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm


To reset the Intermatic device

If the Intermatic device was not detected, you may need to reset the device through a Z-Wave exclusion before it can successfully connect with the SmartThings Hub. To do so in the SmartThings Classic app:

  1. Tap the menu (Android) / More (iOS)
  2. Tap the Hub
  3. Tap Z-Wave Utilities
  4. Tap General Device Exclusion
  5. When prompted, press and release the programming button

After the app indicates that the device was successfully removed from SmartThings, follow the first set of instructions above to connect the Intermatic device.


To remove the Intermatic device from SmartThings

If the Intermatic device is connected but not operating as normal, you may need to remove the device and reconnect it with the SmartThings Hub.

To remove the device via the SmartThings Classic app:

  1. Tap My Home
  2. Tap Things
  3. Select the device
  4. Tap the gear icon
  5. Tap Remove
  6. Confirm removal
  7. When prompted, perform the exclusion procedure to remove the device from the mobile app and from the SmartThings Hub



File Size
Intermatic-HA03C-Manual.pdf 100 KB
Intermatic-HA01C.pdf 400 KB
Intermatic-HA02C.pdf 100 KB
Intermatic-HA04C.pdf 90 KB
Intermatic-HA05C.pdf 200 KB