SmartThings Support

Fidure Thermostat (A1-730)

For ultimate comfort and energy savings in your home, a smart thermostat is a smart choice. The Fidure Thermostat utilizes an adaptive algorithm for highly accurate temperature control, measuring the right combination of room and air temperatures. This device is so smart, it’s even unaffected by drafts.

This thermostat is simple to install, program, and use. Plus, its easy-to-read screen automatically adjusts to ambient light conditions.

The Fidure Thermostat communicates via ZigBee and can be connected with SmartThings Classic to automate and customize your indoor climate control. Set up a Routine to turn down the thermostat when you leave home, or tell the thermostat to switch on when motion is detected. It also acts as a ZigBee repeater to extend the range of your ZigBee network.

Note: The Fidure Thermostat not an officially supported Works with SmartThings device. You can connect it to your SmartThings Classic setup, but performance may vary and we will not be able to provide support or assistance.



To connect the Fidure Thermostat with the SmartThings Hub

First, install the Fidure Thermostat according to its installation guide, which can be downloaded from the link at the bottom of this article.

Next, in the SmartThings Classic app:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. While the Hub searches, follow the thermostat’s process for joining a ZigBee HA 1.2 network (for more information, consult the manual):
    1. On the thermostat, access the menu
    2. Select Settings
    3. Select Network
    4. Select Join Network
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm


To remove the Fidure Thermostat from SmartThings

If the Fidure Thermostat was not discovered, or if it’s not performing optimally with SmartThings, you may need to remove and reset the device in order for it to successfully integrate with your SmartThings network.

First, remove the device from the SmartThings Classic app:

  1. Tap My Home
  2. Tap Things
  3. Tap the device you wish to remove
  4. Tap the gear icon
  5. Tap Remove
  6. Confirm removal (this cannot be undone)

Next, instruct the Fidure Thermostat to leave the ZigBee network:

  1. On the thermostat, access the menu
  2. Select Settings
  3. Select Network
  4. Select Leave Network



File Size
A1-730-Installation-Guide.pdf 400 KB
A1-730-Manual.pdf 300 KB