SmartThings Support

Keen Home Smart Vent

For a greener home and precise control over your home's heating and cooling, add a smart vent to your SmartThings setup. The Keen Home Smart Vent is a ZigBee-controlled device with temperature sensors, air pressure sensors, and automatic airfoil louvers.

This smart vent retrofits existing floor, wall, and ceiling air vents, allowing you to make any room its very own zone. And with multiple Smart Vents communicating with one another, you can effortlessly regulate airflow throughout the whole home. Put the air conditioning on full blast in a too-hot bedroom, or automatically shut the vent to a room that's not in use for most of the day.

 

 

To connect the Smart Vent with the SmartThings Hub

First, install the Smart Vent according to its installation guide, which can be downloaded from the link at the bottom of this article.

Next, in the SmartThings mobile app:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. While the Hub searches, pull the green power tab on the Smart Vent to activate it
    • If the power tab has already been pulled, consult the reset instructions below
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm

 

To reset the Smart Vent

If the Smart Vent was not discovered, you may need to reset the device before it can successfully connect with the SmartThings Hub. To do this:

  1. Press the black factory reset button beside the top louver/on the back of the Smart Vent's battery compartment 5 times
  2. The LED will start double blinking green to indicate the Smart Vent was properly reset and is attempting to pair with a Hub

After the device is successfully reset:

  1. Tap My Home
  2. Under Things, tap Add a Thing at the bottom of your Things list
  3. The app will say Looking for devices…
  4. The Hub should then automatically discover the Smart Vent, as long as the vent is powered and its LED is double blinking green
  5. When the device is discovered, it will be listed at the top of the screen
  6. Tap the device to rename it and tap Done
  7. When finished, tap Save
  8. Tap Ok to confirm

 

To remove the Smart Vent from SmartThings

If the Smart Vent is connected but not operating as normal, you may need to remove the device and reconnect it with the SmartThings Hub.

To remove the device via the SmartThings app:

  1. Tap My Home
  2. Tap Things
  3. Select the device
  4. Tap the gear icon
  5. Tap Remove
  6. Confirm removal (this cannot be undone)

 

For technical specifications and product details, visit our Works With SmartThings page here.

 

Get In Touch